![]() ![]() Breast plate enameled black drive gear red bright parts nickel plated. Rod-type frame hardwood handles adjustable breast plate three-jaw, spring-type chuck adjustable from 0 to 3/8 inch. Frame and breast plate casting painted black drive gear red bright parts nickel plated. Spring type chuck adjustable from 0 to 1/2 inch. Malleable iron frame hardwood handles D-type side handle non-adjustable gear guide speeds adjusted by turning shifter knob on frame leather-strap breast plate spindle runs on hardened steel cone bearing and ball bearings three-jaw, Frame painted black drive gear red bright parts nickel plated. ![]() Malleable iron frame hardwood handles D-type top handle non-adjustable gear guide speeds adjusted by turning shifter knob on frame adjustable breast plate two-jaw chuck with two sets of jaws-one for round, one for square-shanked bits. Manufactured by Millers Falls as of 1931. Optional D-type handle available 1913-1930. 1 Morse taper bits without swapping swapping jaws. 1935-two-jaw chuck holds square shanked, round and No.1896-malleable iron frame hardwood handles non-adjustable gear guide speeds adjusted by turning shifter knob on frame adjustable breast plate spindle runs on hardened steel cone bearing two-jaw chuck with two sets of jaws-one for round, one for square-shanked bits. Illustration from 1911 catalog, where the company used an image of a No. Malleable iron frame hardwood handles non-adjustable gear guide speeds adjusted by turning shifter knob on frame adjustable breast plate spindle runs on hardened steel cone bearing and ball bearings three-jaw, Malleable iron frame hardwood handles non-adjustable gear guide speeds adjusted by turning shifter knob on frame adjustable breast plate spindle runs on hardened steel cone bearing three-jaw, Cast iron parts of frame and breast plate painted black drive gear red unpainted metal parts are polished, rather than nickel plated. Rod-type frame hardwood handles single release button allows speed change without removing drill from work ball thrust bearing adjustable breast plate three-jaw, spring-type chuck adjustable from 0 to 1/2 inch. Malleable iron frame hardwood handles non-adjustable gear guide speeds adjusted by turning shifter knob on frame adjustable breast plate two-jaw chuck for holding square-shanked bits. Then too, production practices varied from catalog copy and illustrations While the company typically stressed new features in its catalogs, it seldom mentioned the disappearance of a feature or the addition of a feature that had become so commonly accepted that it was no longer noteworthy. The features listed for each drill may differ from actual examples. It's a smidge loose in the hole in the jaw, but doesn't appear to bind or get in the way, so I think it's good.This listing has been developed from information found in Goodell Brothers and Goodell-Pratt Company catalogs. It cuts easily with standard dykes, and I just eyeballed it against the least-damaged original spring for length. You can order any length you want - I think I bought around a foot. I don't have my record of which diameter wire I bought, but I probably got the stainless 0.020". I think the product I ended up using was: 1/8" 0.125" (3.18mm) OD Stainless/Carbon steel Compression spring. I am not a big fan of the stained handles, and I hope my next project will be a tropical wood that I can show off without staining.įor the chuck springs, back in December I measured them with a micrometer and got a close match in size, then I ordered a length on ebay. ![]() ![]() I'm basing my manufacturing date estimate off of the oldtoolheaven entry that says the handle was 'mahogany-finished hardwood' starting in 1926, which is how I interpreted the original finish on the handle. ![]()
0 Comments
Leave a Reply. |